Section
3–5
MN1229
Control Signal Wiring Continued
Figure 3-2 Active HIGH/LOW Relationship
Active
Low
Active High
GND
ext
(Sink)
+24VDC
GND
V
ext
(Source)
GND
+24VDC
X3
Pin 7 - CREF
Pin 9 - Enable
Pin 10 - CW
Pin 1
1 - CCW
Pin 12 - Hold
Pin 13 - Reset
Pin 16 - Machine Input 1
Pin 17 - Machine Input 2
Note: These pins are shown wired together. Although this can be done,
each input is usually connected to a switch for individual control of
each input condition. Pins 16 and 17 are optional inputs and are
described later in this section.
A typical wiring control diagram is shown in Figure 3-3.
1. Connect the CREF signal wire to X3-7.
2. Connect the Enable signal wire to X3-9.
3. Connect the CW Limit signal wire to X3-10.
4. Connect the CCW Limit signal wire to X3-11.
5. Connect the Hold signal wire to X3-12 (optional).
6. Connect the Reset (Fault Reset) signal wire to X3-13 (optional).
The Reset signal (Fault Reset) can only reset the following fault types: Over
voltage, Under voltage, Resolver fault, or Control Temperature fault.
Note: Current input for each control input X3-9 to X3-17 is
I
in
=10mA maximum (for each input).
Control Signal Wiring Continued
Figure 3-2 Active HIGH/LOW Relationship
Active Low Active High
GNDext
Vext
(Sink)
(Source)
+24VDC GND
GND +24VDC
•
•
•
•
•
X3
Pin 7 - CREF
Pin 9 - Enable
Pin 10 - CW
Pin 11 - CCW
Pin 12 - Hold
Pin 13 - Reset
Pin 16 - Machine Input 1
Pin 17 - Machine Input 2
Note: These pins are shown wired together. Although this can be done,
each input is usually connected to a switch for individual control of
each input condition. Pins 16 and 17 are optional inputs and are
described later in this section.
A typical wiring control diagram is shown in Figure 3-3.
1. Connect the CREF signal wire to X3-7.
2. Connect the Enable signal wire to X3-9.
3. Connect the CW Limit signal wire to X3-10.
4. Connect the CCW Limit signal wire to X3-11.
5. Connect the Hold signal wire to X3-12 (optional).
6. Connect the Reset (Fault Reset) signal wire to X3-13 (optional).
The Reset signal (Fault Reset) can only reset the following fault types: Over
voltage, Under voltage, Resolver fault, or Control Temperature fault.
Note: Current input for each control input X3-9 to X3-17 is
Iin=10mA maximum (for each input).
MN1229 3-5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
