Baldor DBSC 100 Series User Manual

Section 1
Introduction and Conformity
1–1
MN1229
Introduction
The Baldor Series Controls represent the latest technology in microprocessor
based motor controls. The user programmable parameters available in every
control provides the ability to customize the control to most any application.
Baldor has tried to ensure that the information in this manual is correct at the
time of printing. The information is subject to change without prior notice.
This document is copyright by Baldor and is supplied with the understanding
that it will not be reproduced or disclosed in whole or in part, without the
express permission of Baldor.
Conformity
This product is only for use in industrial applications as described in EN 60204
and VDE 0160. This means use DBSC100 in stationary ground based
applications only
. It is a component only and is not intended for immediate use
within the meaning of “Safety law of appliance”, “EMC Law” or “Machine
directive”. It is the responsibility of the user to verify that the equipment the
DBSC 100 is used in complies with all applicable regulations.
The DBSC 100 Series AC Servo Control is intended for use in industrial
installations. These controls are designed for applications that require speed
control of three phase AC Servo motors.
The DBSC 100 conforms to the following standards:
DIN VDE 0100
Power installations with nominal voltages
≤ 1000 VAC.
DIN VDE 01
10
Dimensioning of clearance tolerances.
DIN VDE 0160
Electronic equipment for use in electrical power
installations.
DIN IEC 326
Design and use of printed circuit boards.
EN 60529
Degrees of protection provided by enclosure.
Section 1
Introduction and Conformity
Introduction
The Baldor Series Controls represent the latest technology in microprocessor
based motor controls. The user programmable parameters available in every
control provides the ability to customize the control to most any application.
Baldor has tried to ensure that the information in this manual is correct at the
time of printing. The information is subject to change without prior notice.
This document is copyright by Baldor and is supplied with the understanding
that it will not be reproduced or disclosed in whole or in part, without the
express permission of Baldor.
Conformity
This product is only for use in industrial applications as described in EN 60204
and VDE 0160. This means use DBSC100 in stationary ground based
applications only. It is a component only and is not intended for immediate use
within the meaning of "Safety law of appliance", "EMC Law" or "Machine
directive". It is the responsibility of the user to verify that the equipment the
DBSC 100 is used in complies with all applicable regulations.
The DBSC 100 Series AC Servo Control is intended for use in industrial
installations. These controls are designed for applications that require speed
control of three phase AC Servo motors.
The DBSC 100 conforms to the following standards:
DIN VDE 0100
DIN VDE 0110
DIN VDE 0160
DIN IEC 326
EN 60529
Power installations with nominal voltages < 1000 VAC.
Dimensioning of clearance tolerances.
Electronic equipment for use in electrical power
installations.
Design and use of printed circuit boards.
Degrees of protection provided by enclosure.
MN1229
1-1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Baldor DBSC 100 Series Specifications

General

Brand	Baldor
Model	DBSC 100 Series
Category	Controller
Language	English