Operation 5-13
MN1276
Tuning
Allows manual or automatic tuning to remove offset drift.
Allows manual or automatic tuning of velocity control
parameters.
Watch
Show or hide the “symbols list bar”.
Show or hide the “system parameters bar”.
Show or hide the “system status bar”.
Gather and plot motor data for two variables.
View the error log.
View the available options for the selected control.
Functions
Enable the control.
Disable the control -- Active: Motor decels to stop then control disables.
Passive: Motor coasts to stop.
Cause motor to stop and maintain position.
Allow you to Jog the position of the motor.
Define up to 12 PLC statements (logical association of input / output conditions).
Motion
Searches for absolute position Zero and hold position at absolute Zero.
Start a positioning move, Direct move or Buffer move.
Terminal
Allows communication with selected control using command set (see Appendix B).
Configure PC COM port 1, 2, 3 or 4 to communicate with the selected control.
Windows
Cascade display of all open software windows.
Tile display of all open software windows.
To Next Page
Loading...
Need help?
General
