Operation 5-3
MN1276
Using The Setup Wizard
The setup software wizard guides you through each step to set the basic
parameters. This wizard is activated automatically after each start-up of the
software. This automatic start of the Wizard can be turned off. It can be activated
(and reset to automatic start) by Help ( Wizard.
Figure 5-1 shows the flowchart of the Setup Wizard.
All selected parameters can be stored in a file. To save the configuration, select
Setup ( Save Configuration. To restore these parameter values or to configure
a several controls with the same parameter sets, select the
Setup ( Restore Configuration.
To Next Page
Loading...
Need help?
General
