Operation 5-5
MN1276
Set up Software Opening menu. Click NEXT to go to the Set up Software. If you have already set
up the parameters and saved them to a file, click FINISH then load the parameter
file using the File ( Open selection.
Start by s electing the Motor and Control and these parameters will be entered automatically for you by
the software for a stock motor. For a custom motor, the motor parameters must be entered on the
general menu. First, click on “Motor” and then select “User Models” in the Library menu. Then, click
“General” to return to this menu and enter all parameters.
To Next Page
Loading...
