Bante Instruments 221 User Manual

03 I General Guide
General Guide
This section is applicable to all models of meters
Introduction
Thank you for selecting the Bante series portable water quality meter,
this product series includes models below.
Single Parameter Meters
Model
Measurement Parameters
221
pH, mV, ORP
320
pH, mV, ORP, ion
321
Ion, mV
322
Water hardness
530
Conductivity, TDS
531
Conductivity, salinity
540
Conductivity, TDS, salinity, resistivity
821
DO
Multiparameter Meters
Model
Measurement Parameters
900P
pH, mV, ORP, ion, conductivity, TDS, salinity, resistivity, DO
901P
pH, mV, conductivity, TDS
902P
pH, mV, ORP, conductivity, TDS, salinity, resistivity
903P
pH, mV, ORP, DO
904P
Conductivity, TDS, salinity, resistivity, DO
This manual provides a step-by-step guide to help you operate these
meters, please carefully read the following instructions according to
the model you have purchased.
Environmental Conditions
Before unpacking, ensure that current environmental conditions meet
the following requirements.
• Relative humidity is less than 80%
• Ambient temperature between 0° C (32° F) and 50° C (122° F)
• No potential electromagnetic interference
• No corrosive gas exists
Packing List
The following list describes all components of the meter. If any items
are missing or damaged, contact the supplier immediately.
Meter, electrode clip

Bante Instruments 221 Specifications

General

Brand	Bante Instruments
Model	221
Category	Measuring Instruments
Language	English