Barco DP2K­-20C

10. Removal and installation of projector covers
10.10 Installation of the rear cover
Necessary tools
Flat screwdriver.
How to install the rear cover of the projector?
1. Install the rear cover of the projector doing the following:
a) B ring the rear cover towards it final position,
b) then gently push the lock ing studs of the top corners into their receivers
B
B
A
Image 10-19
Install rear housing
2. Secure the rear c over by locking the ca ptive screws at the bottom corners of the rear c over.
Image 10-20
Fasten rear housing
98 R59770351 DP2K-20C 02/02/2010