10. Removal and installation of projector covers
10.5 Removal of the rear cover
WARNING: This procedure may only be performed by qualified technical service personnel.
Necessary tools
Flat screwdriver.
How to remove the rear cover from the projector?
1. Release the two c aptive screws at the bottom corners of the rear cov er, using a flat screw driver.
Image 10-9
Release rear cover
2. Remov e the rear cover of the projector d oing the following:
a) gen tly pull out the top corners of the rear c over,
b) then move the rear cover away from the projector.
A
A
B
Image 10-10
Remove rear cover
92 R59770351 DP2K-20C 02/02/2010
To Next Page
Loading...
