3. Physical installation
4. Secure the power c ord with the chassis of the projector by using two cable ties ( A) and by fastening the cable gland (B) as
illustrated.
Use the appropriate screws, depending on the diameter o f the cable (two sets of screws are delivered with the projector in a
separate b ag). Turn in both s crews so that the end of the s crew s are far enough in the plastic part and that the f eet of that part
grip in the chassis. Check the fi xation by pulling on the gland.
A
A
Image 3-8
5. Reinstall the cover of the main AC com partment.
Image 3-9
6. Reinstall the rear cover and lamp cover of the projector.
R59770351 DP2K-20C 02/02/2010
21
To Next Page
Loading...
