152 ImagePRO-II • User’s Guide
B. Remote Control Protocol
ImagePRO-II Remote Commands
• Query Response: Input Settings in the following format:
UINPUT --deint (deinterlacing type) --motion (motion
threshold) --pulldown (pulldown detection)
lìíéìí=oÉãçíÉ=`çãã~åÇë
l`e
• Description: Output Channel settings
• Required parameter: --och (output channel)
• Parameters:
--och (output channel): 0-1
--sharp (sharpness): -10..10
--flicker (flicker filter): 0..20
--strobemode (Strobe mode): 0 = OFF, 1 = ON
--strobeint (Strobe interval): 2..100
--flip (flip mode): 0 = None, 1 = HFlip, 2 = VFlip , 3 = HVFlip
• Query Format:
OCH --och (output channel) --?
• Query Response: Output Channel settings in the following format:
OCH --sharp (sharpness) --flicker (flicker)
--strobemode (Strobe mode) --strobeint
Strobe interval) --flip (Flip mode)
ljdo
• Description: Output Manager settings
• Parameters:
--applyedid (connector): 0-3
0 = DVI, 1 = HD15, 2 = HDMI, 3 = DP
--save (save output configuration)
--recall (recall output configuration)
--reset (reset output configuration)
• Query Format: (n/a)
sáÉï=oÉãçíÉ=`çãã~åÇë
sfbt
• Description: View Settings
• Required parameters:
--con (connector)
--ch (channel): Required for --percent or --pixel parameters. Not
required for --units or --save or --recall or --reset
To Next Page
Loading...
