82 ImagePRO-II • User’s Guide
4. Menu Orientation
Using the System Menu
Figure 4-69. Backup Failed Message
oÉëíçêáåÖ=`çåÑáÖìê~íáçå=cáäÉë
To restore a system configuration file that is stored on a flash drive, use the following
procedure.
1. Insert the flash drive in the ImagePRO-II’s front-panel USB port.
2. From the System Menu, select the USB Backup/Restore Submenu.
3. Select Restore Config. The USB Restore Config Submenu appears, as shown
in the following illustration.
Figure 4-70. USB Restore Config Submenu
4. Press SEL and scroll through the list of configuration files. When you locate the
file you want, press SEL again.
5. Scroll to Restore Config and press SEL.
A message confirms the restore operation and instructs you to reboot the
ImagePRO-II.
_~ÅâáåÖ=ré=içÖç=cáäÉë
After you capture and save a logo image, you can back it up to a flash drive, using the
following procedure:
1. On the System Menu, select USB. The USB Backup/Restore Submenu
appears.
2. Select Backup Logo. The USB Backup Logo Submenu appears, as shown in
the following illustration. The navigation cursor is at the default logo filename.
Backup failed
Please check USB
connection and
retry
USB RESTORE CONFIG
> SysBackup1
Restore Config
(FAT filesystem only)
Note
You must reboot the ImagePRO-II to use the restored
configuration file.
To Next Page
Loading...
