ImagePRO-II • User’s Guide 83
4. Menu Orientation
Using the System Menu
Figure 4-71. USB Backup Logo Submenu
3. If you wish to change the name of the backup logo, press SEL. Use the ADJUST
knob to change the name, as described in Saving a Custom Format on page 68.
Press SEL again when you complete the name change.
4. Scroll to Backup Logo and press SEL.
A message confirms the success of the backup operation.
oÉëíçêáåÖ=içÖç=cáäÉë
To restore a logo file that is stored on a flash drive, use the following procedure.
1. Insert the flash drive in the ImagePRO-II’s front-panel USB port.
2. From the System Menu, select the USB Backup/Restore Submenu.
3. Select Restore Logo. The USB Restore Logo Submenu appears, as shown in
the following illustration.
Figure 4-72. USB Restore Logo Submenu
4. Press SEL and scroll through the list of logos. When you locate the file you want,
press SEL again.
5. Scroll to Restore Logo and press SEL.
A message confirms the success of the restore operation, and instructs you to
reboot the ImagePRO-II.
pÉííáåÖ=bíÜÉêåÉí=léíáçåë
Using the Ethernet Submenu, shown in the following illustration, you can view and change
certain Ethernet settings.
USB BACKUP LOGO
> LogoBackup1
Backup Logo
(FAT filesystem only)
USB RESTORE LOGO
> Logo1
Restore LOGO
(FAT filesystem only)
Note
You must reboot the ImagePRO-II to use the restored logo.
To Next Page
Loading...
