R5911443 /08 UDM154
10.21 Capture mode
Why use capture mode?
Various technical features are used inside the projector to display the best possible image on the projected
surface. However, in expositions and setups where visitors are expected to film or take pictures of the
projected surface, some of these technical features may have side-effects on the captured footage, such as
solarization.
Enabling the Capture mode feature disables some of the technical features of the projector that are known to
cause solarization and gives the visiting audience an experience they can “capture” and post on social media
without worries.
How to enable Capture mode
1. In the main menu, navigate to Settings → System .
2. In the Lens menu, click Capture mode to toggle between On and Off.
Image 10–70 System menu, Capture mode disabled Image 10–71 System menu, Capture mode enabled
10.22 Login to advanced settings
How to login
1. In the main menu, Settings → Maintenance → Login.
Image 10–72
The Login menu is displayed.
Image 10–73
GUI – System Settings
To Next Page
Loading...
Need help?
General
