25R5911443 /08 UDM
Warning: Never switch on the projector if the OVERVOLTAGE status light lit up. Neglecting will
cause irreversible damage to the projector.
► If no, proceed with the next step.
2. Press the mains switch (reference 2) to switch on this projector.
Image 2–6
• When '0' is pressed, the projector is switched off.
• When 'I' is pressed, the projector is switched on.
The projector starts up to ready mode. The Power on/off button will blink until ready mode is achieved.
Once in ready mode, the Power on/off button will be lit WHITE.
The start up screen is displayed on the touch panel.
Image 2–7
3. Press the Power on/off button on the projector, or the Power On button on the remote control.
The projector will continue to power on mode. The Power on/off button will blink until the projector is
ready. Once the projector is ready, the Power button will be lit BLUE.
Image 2–8
The background image of the startup screen and info screens can be changed with Projector
Toolset with an installed UDM plug-in.
2.3 Start image projection
Connect the source
1. Connect the source cable with the appropriate input port on the Input & Communication module.
Tip: See chapter “Input & Communication”, page 37, for more info about supported input formats.
Getting Started
To Next Page
Loading...
Need help?
General
