BARTEC BENKE A Series

Questions and Answers

C
Charles JohnsonAug 10, 2025
What to do if the pump will not start in BARTEC BENKE A Series?
- L
  Linda CummingsAug 10, 2025
  If the pump of your BARTEC BENKE Measuring Instruments won't start, first select the direction. If the impeller doesn't move, change the direction several times and switch the pump on until it does; you can also grease the impeller with Vaseline. If the speed is too low, increase the speed setting. Finally, if there's a frequency converter fault, rectify it by pressing the STOP/RESET button and then START.
M
michael66Aug 15, 2025
How to troubleshoot no power supply to gauging unit in BARTEC BENKE A Series?
- H
  Heather PinedaAug 15, 2025
  If you have no power supply to the gauging unit of your BARTEC BENKE Measuring Instruments, make sure the mains cable is properly connected and operational. Check that the mains switch is on. Also, verify that the residual-current circuit-breaker or fuse in the switch cabinet hasn't tripped and activate it if needed. If there's still no supply voltage, it should be restored by qualified personnel only.
J
John CareyAug 20, 2025
What to do if there is no network connection to gauging unit in BARTEC BENKE A Series Measuring Instruments?
- K
  Kristy MorganAug 20, 2025
  If you have no network connection to the gauging unit of your BARTEC BENKE Measuring Instruments, ensure the network cable is properly connected and working. Configure the IP address if it hasn't been already. Check the 24V supply in the switch cabinet if there's no power at the switch. If the switch is defective, replace it.
R
Robin RogersAug 26, 2025
Why is System 3003 unavailable on my BARTEC BENKE A Series Measuring Instruments?
- C
  caleb06Aug 26, 2025
  If the System 3003 of your BARTEC BENKE Measuring Instruments is unavailable, first ensure there is a network connection. If not, establish one. If the system is not configured, then configure System 3003.
B
Brett WilsonAug 30, 2025
What to do if there is no compressed air supply for BARTEC BENKE A Series?
- K
  Katherine ColemanAug 31, 2025
  If you have no compressed air supply for your BARTEC BENKE Measuring Instruments, connect an operational supply hose if it's not connected or is defective. If the pressure setting on the service unit is too low, set the pressure to a maximum of 8 bar.
C
Cynthia JenkinsSep 4, 2025
What to do if valves V1 to V4 cannot be activated on BARTEC BENKE Measuring Instruments?
- R
  rojassophiaSep 4, 2025
  If valves V1 to V4 cannot be activated in your BARTEC BENKE Measuring Instruments, establish a compressed air supply.

BARTEC BENKE A Series Specifications

General

Category	Measuring Instruments
Series	A Series
Manufacturer	BARTEC
Explosion Protection	Ex-proof
Protection Class	IP65
Material	Stainless Steel (typical, may vary depending on the specific model)