BARTEC BENKE A Series - Default Chapter; Table of Contents

Contents
I-1
Instruction Manual PETRO 3003 VOLUTANK Gauging unit BA 140918
Contents
Contents Page Issue date
1 Introduction _______________________________________ 1
1.1 Information about our customers documentation ___________ 1
1.2 Manufacturer Information _____________________________ 2
1.2.1 Service and Hotline of manufacturer_____________________ 2
1.2.2 Type plate _________________________________________ 2
1.3 Qualification of operating personnel _____________________ 3
2 Safety precautions _________________________________ 4
2.1 Intended use _______________________________________ 4
2.2 Improper use _______________________________________ 5
2.3 Safety hazards and accident prevention __________________ 5
2.3.1 Residual hazards ___________________________________ 5
2.4 Safety notices on the gauging unit ______________________ 6
2.5 Further safety instructions _____________________________ 7
2.5.1 Conduct in the event of an emergency ___________________ 7
2.6 Rectification of faults _________________________________ 7
3 System description _________________________________ 8
3.1 Construction of the gauging unit ________________________ 8
Schematic structure _________________________________ 8
3.2 Technical Data _____________________________________ 9
3.3 Dimensions ________________________________________ 9
4 Storage, transport and start of operation ______________ 10
4.1 Storage and transportation of the gauging unit ____________ 10
4.2 Complete drainage of gauging unit _____________________ 10
4.3 Putting the gauging unit into operation __________________ 12
4.3.1 Requirements _____________________________________ 12
4.3.1.1 Required vehicle version _____________________________ 14
4.3.1.2 Configuring System 3003 ____________________________ 14
4.3.1.3 Gauging positions and setting for logical I/Os ____________ 15
4.3.2 Installing the PC software ____________________________ 18
4.3.2.1 Configuring the IP address ___________________________ 21
Windows XP ______________________________________ 21
Windows 7 ________________________________________ 24
4.3.3 Connections ______________________________________ 27
4.3.3.1 Power supply ______________________________________ 27
4.3.3.2 Compressed air ____________________________________ 27
4.3.3.3 Network connections ________________________________ 28
4.3.3.4 Hose connections __________________________________ 29
5 Operation of the gauging unit _______________________ 30
5.1 "ALI menu" on System 3003 __________________________ 30
5.2 Hose connection from the vehicle to "IN" on the gauging unit 31
5.3 "Gauging unit" PC program ___________________________ 31
5.3.1 "Configuration" tab _________________________________ 33
5.3.2 „System 3003“ tab __________________________________ 34
5.3.3 “Manual control“ tab ________________________________ 36
5.3.4 Special function “pump over“ _________________________ 37
5.3.5 “Gauge” tab _______________________________________ 38
5.3.5.1 "Settings" _________________________________________ 38
5.3.5.2 “Overview” ________________________________________ 39
5.3.5.3 Stopping the gauging process ________________________ 43
5.3.5.4 General procedure during the gauging process ___________ 44
6 Servicing, maintenance and cleaning _________________ 45
6.1 Maintenance schedule ______________________________ 45
6.2 Servicing and replacing the impeller ___________________ 46
6.3 Troubleshooting ___________________________________ 47