Operation of the gauging unit
36
Instruction Manual PETRO 3003 VOLUTANK Gauging unit BA 140918
5.3.3 “Manual control“ tab
The “Manual control” tab has the following functions:
Test the gauging unit hardware,
Transfer pumping operations when capacity measurement is
not in progress,
Pumping is no System 3003 is connected.
The valves necessary for gauging on the vehicle can be controlled as can
the hardware of the gauging unit itself.
All the valves can be switched individually on the gauging unit, the pump
controlled, and MID and level sensor messages displayed.
The levels in the vehicle chambers are updated during the manual control
process
NOTE:
● The pump speed is set in increments of 10 per cent.
● There must be some fluid in the system for the correct flow rate to be
displayed.
To Next Page
Loading...
