47-2 9424200996
BESTCOMSPlus® Software BE1-11m
Installation
BESTCOMSPlus software is built on the Microsoft® .NET Framework. The setup utility that installs
BESTCOMSPlus on your PC also installs the BE1-11 plugin and the required version of .NET Framework
(if not already installed). BESTCOMSPlus operates with systems using Windows® 7 SP1, Windows 8.1,
and Windows 10 version 1607 (Anniversary Edition) or later. System recommendations for the .NET
Framework and BESTCOMSPlus are listed in Table 47-1.
Table 47-1. System Recommendations for BESTCOMSPlus and the .NET Framework
1 GB (minimum), 2 GB (recommended)
200 MB (if .NET Framework is already installed on PC)
4.5 GB (if .NET Framework is not already installed on PC)
200 MB (if .NET Framework is already installed on PC)
4.5 GB (if .NET Framework is not already installed on PC)
To install BESTCOMSPlus, a Windows user must have Administrator rights.
Install BESTCOMSPlus®
Do not connect a USB cable until setup completes successfully.
Connecting a USB cable before setup is complete may result in
unwanted or unexpected errors.
1. Insert the BE1-11 product CD into the PC CD-ROM drive.
2. When the BE1-11 Product CD menu appears, click the installation button for BESTCOMSPlus. The
setup utility installs BESTCOMSPlus, the .NET Framework (if not already installed), the USB driver,
and the BE1-11 plugin for BESTCOMSPlus on your PC.
When BESTCOMSPlus installation is complete, a Basler Electric folder is added to the Windows
programs menu. This folder is accessed by clicking the Windows Start button and then accessing the
Basler Electric folder in the Programs menu. The Basler Electric folder contains an icon that starts
BESTCOMSPlus when clicked.
Activate the BE1-11 Plugin for BESTCOMSPlus®
The BE1-11 plugin is a module that runs inside the BESTCOMSPlus shell. The BE1-11 plugin contains
specific operational and logic settings for only the BE1-11m. Uploading settings to the BE1-11m is
possible only after activating the BE1-11 plugin.
The BE1-11 plugin can be activated automatically or manually. Automatic activation is achieved by using
a USB cable to establish communication between the BE1-11m and BESTCOMSPlus. Manual activation
is initiated by contacting Basler Electric for an activation key and entering the key into BESTCOMSPlus.
Manual activation is useful if you want to create a settings file prior to receiving your BE1-11m. Note that if
a BE1-11m is not connected, you will not be able to configure certain Ethernet settings. Ethernet settings
can be changed only when an active USB or Ethernet connection is present. Refer to the Communication
chapter.
To Next Page
Loading...
