Baumer VCXG .I - Configurable Outputs

89
7.6.1.3 CongurableOutputs
With this feature, Baumer gives you the option to wire the output connectors to internal
signals that are controlled on the software side.
On CX cameras, the output connector can be wired to one of the provided internal signals:
Signals
Off UserOutput3 (only ≥ Rel. 2)
TriggerReady UserOutput4 (only VCXG.I / .XT)
ExposureActive Timer1
UserOutput1 ReadoutActive
UserOutput2 (only ≥ Rel. 2)
(Output) Line 0
state high
state low
(Output) Line 1*
state high
state low
(Output) Line 2*
state high
state low
IO Matrix
state selection
(inverter)
signal selection
(software side)
Signals
* Example, if the two GPIO's are used as outputs. (only VCXG / VCXU)
* VCXG.I / VCXG.I.XT is equipped with four fixed Outputs (Line0 ... Line3)
◄Figure50
IO matrix