Beck IPC@CHIP Series

To Next Page

To Previous Page

IPC@CHIP DK41 / DK51

Getting Started V2.2

In the terminal window (HyperTerminal), press the ‘Enter’ key once until you see the ‘A:>’ prompt.

Enter the command ‘ipcfg’ followed by the ‘Enter’ key. The output will show the current IP configuration

of all the supported device interfaces. For example:

A:\>ipcfg

Device = NE2000

Type = ETH

Idx = 2

IP = 192.168.200.1

Netmask = 255.255.255.0

DHCP = 0

Mac = 00 30 56 F0 20 C2

Device = LOOPBACK

Type = LPK

Idx = 1

IP = 127.0.0.1

Netmask = 255.255.255.255

Gateway = 192.168.200.10

The figure above shows the IP configuration of the Ethernet device and of the “Internal loopback

device”.

Beck IPC@CHIP Series - Page 10