Need help?Do you have a question about the BECS BECSys3 and is the answer not in the manual?
General| Brand | BECS |
|---|---|
| Model | BECSys3 |
| Category | Controller |
| Language | English |
Details controller and relay voltage and current ratings.
Step-by-step guide for physically mounting the controller unit.
Alerts users to disconnect power before servicing the unit.
Advises on correct feeder connections to prevent chemical interactions.
Proper handling and preparation of sensors, including wetting caps.
How to connect the pH and ORP sensors to the controller.
Initial steps for wiring, including opening the controller cover.
Connecting power and wiring directly to terminal blocks.
How to configure relay power sources.
Detailed instructions for wiring pH control relay (Relay 1).
Detailed instructions for wiring ORP control relay (Relay 2).
Configuring and wiring Relay 3 for various functions.
Importance and connection of flow switches for safety.
Specifics on installing the paddlewheel flow switch.
Wiring details for CCS140 and ECL6 chlorine sensors.
Table detailing dip switch positions and their functions.
Setting dip switches for Relay 3 functions like Alarm or Booster.
Steps to access the controller's program menu with access codes.
Configuring high and low alarm points for pH and ORP.
Performing a two-point calibration for the pH input.
Performing a two-point calibration for the ORP input.
Setting failsafe timers for chemical feed systems.
Calibrating the CCS140 ppm probe.
Calibrating the ECL6 ppm probe.
Steps to change pH, ORP, and ppm set points.
Performing a single point calibration for pH.
Performing single point calibration for ppm probe or calculated.
Steps to resolve 'Calibration Error' messages.
How to address 'Probe Error' messages, often requiring probe replacement.
Procedures for cleaning pH and ORP sensor electrodes.
To Next Page
