BECS BECSys3 - Sensor Preparation and Connection; Sensor Preparation Steps; Sensor Connection to Controller

Page 2
www.becs.com 9487 Dielman Rock Island Ind Dr, St. Louis, MO 63132
Installation and Technical Manual Rev: H10
U
U
n
n
p
p
a
a
c
c
k
k
i
i
n
n
g
g
Your Shipping package should contain these items:
A. The BECSys3 Controller
B. pH Sensor
D. Flow Cell Kit
E. Rotary or Reed flow switch
F. This manual (not shown)
G. Optional Sensors (not shown)
A B C D
G
G
e
e
n
n
e
e
r
r
a
a
l
l
G
G
u
u
i
i
d
d
e
e
l
l
i
i
n
n
e
e
s
s
Proper installation and use of the BECSys controller depends on the specific needs of the application. Read the manual
completely before starting the installation and ensure all guidelines and recommendations are followed. All components
should be mounted and the flow cell plumbing installed and pressure tested before wiring the controller. Ensure
compliance with all applicable plumbing and electrical codes during the installation as well.
F
F
i
i
r
r
m
m
w
w
a
a
r
r
e
e
V
V
e
e
r
r
s
s
i
i
o
o
n
n
This manual was written for firmware v2.06. If you received newer firmware but did not receive a copy of the manual
covering that version of firmware, please contact your distributor.
Warning: The Sensors are very fragile and must be handled with care. The tips of the probes must be kept
wet at all times, requiring the wetting caps to remain in place until they are ready to be installed. The probes
must be stored in temperatures above freezing.
Rotary
Reed
or
Caution: The BECSys controller should not be installed where it is accessible to the public.