Belden Hirschmann OCTOPUS 8TX PoE-EEC - Configuration (Optional)

Installation OCTOPUS 8TX-EEC
Release 07 01/2021
35
2.6 Configuration (optional)
This applies to the following device variants only:
 OCTOPUS 8TX-EEC
 OCTOPUS 8TX PoE-EEC
The device is immediately ready for operation with its default settings, from
the factory.
You have the option to change the settings according to your requirements
using the ACA M12 interface.
You can find the configuration parameters described in a separate overview.
See table 1 on page 39.
Requirements:
 Switch Programming Tool
You can download the software for free on the Internet from the
Hirschmann product pages:
www.hirschmann.com/en/QR/Switch-Programing-Tool
 M12 USB Adapter
You can connect the storage medium ACA21-M12 (EEC) or ACA22-M12
(EEC) to your PC using the M12 USB Adapter.
The M12 USB Adapter is available as an accessory.
See “Accessories” on page 54.
 ACA21-M12 (EEC) or ACA22-M12 (EEC)
You have the option to transfer configuration data to your device or read
out the configuration using a storage medium.
The storage medium is available as an accessory.
See “Accessories” on page 54.