TM 55-1520-228-BD
ELECTRICAL AND AVIONICS SYSTEM
7.
Twist the center conductor from the
radiating element of the antenna to the
center conductor of the coax.
Make a
good mechanical joint and insulate with
tape.
8.
Ground the pigtail from the coax
antenna by wrapping and twisting it
around the plug where the coax was
disconnected.
9.
Secure with tape to hold the
antenna and coax in place inside the
tail boom. Replace the structural panel
and secure with screws.
NOTE
Antenna must be at right angle
(90°) to aircraft skin to radiate
R.F. energy. Do not tape antenna
to skin of aircraft.
10.
Using tape, tape a one to two ounce
weight below the 52 resistor as shown
in Figure 11-47.
11-48
To Next Page
Loading...
