10
Everyone who works with this A-ISOMETER
®
must take note of this operating
manual, and in particular of the safety information.
In addition to this, the rules and regulations concerning accident prevention
which are valid for the operating location must be obeyed.
Personnel
Only appropriately qualified staff may work with the A-ISOMETER
®
.The term
“qualified“ means that such staff are familiar with the assembly, commissioning
and operation of the product and that they have undergone training which is
appropriate to their activities.
The staff must have read and understood the safety chapter and the warnings
in these operating instructions.
About the operating manual
This operating manual has been compiled with the greatest possible care.
Nevertheless, errors and mistakes cannot be entirely ruled out. The BENDER
companies assume no liability whatsoever for any injury to persons or damage
to property which may be sustained as a result of faults or errors in these
operating instructions.
Hazards when handling the A-ISOMETER
®
IRDH375
The IRDH375 A-ISOMETER
®
is constructed according to the state-of-the-art and
the recognized safety engineering rules. Nevertheless, when it is being used,
hazards may occur to the life and limb of the user or third parties, or there
may be adverse effects on the A-ISOMETER
®
or on other valuable property. The
A-ISOMETER
®
must only be used
• for the purpose for which it is intended
• when it is in perfect technical condition as far as safety is concerned.
Any faults which may impair safety must be eliminated immediately. Impermis-
sible modifications and the use of spare parts and additional devices which are
not sold and recommended by the manufacturer of the devices may cause fires,
electric shocks and injuries.
Unauthorized persons must not have access to or contact with the A-ISOMETER
®
.
Safety information
To Next Page
Loading...
