11
Warning signs must always be easily legible. Damages or illegible signs must
be replaced immediately.
Inspection, transport and storage
Inspect the dispatch packaging and equipment packaging for damage, and
compare the contents of the package with the delivery documents. In the event
of damage in transit, please notify the BENDER company immediately.
The devices must only be stored in rooms where they are protected against dust
and moisture, and spraying or dripping water, and where the indicated storage
temperatures are maintained.
Note
Make sure that the operating voltage is correct !
Prior to insulation and voltage tests the A-ISOMETER
®
must be disconnected
from the power system for the duration of these tests.
In order to check the proper connection of the device, it is recommended to
carry out a functional test.
Make sure that the basic settings meet the requirements of the system.
Children and unauthorized persons must not have access to or contact with the
A-ISOMETER
®
.
Explanations of symbols and warnings
The following designations and signs are used for hazards and warnings in
BENDER documentation.
This symbol means a possible threat of danger to the life and
health of human beings.
• Failure to comply with these warnings means that death,
serious physical injury or substantial damage to property may
ensue if the relevant precautions are not taken.
Safety information
To Next Page
Loading...
