9
Safety information
Use for the intended purpose
The A-ISOMETER
®
is intended exclusively for monitoring the insulation resi-
stance of IT systems. Any other use, or any use which goes beyond the
foregoing, is deemed to be use other than for the intended purpose. The
BENDER Companies shall not be liable for any losses or damage arising
therefrom.
Use for the intended purpose also includes:
• compliance with all information contained in the operating instructions, and
• compliance with the inspection and test intervals and the calibration
intervals.
As a basic principle, our „General Conditions of Sale and Delivery“ shall apply.
At the latest, these shall be available to the operator when the contract is
concluded.
Warranty and liability
Warranty and liability claims in cases of damage to persons and property shall be
excluded if they are attributable to one or more of the following causes:
• use of the A-ISOMETER
®
other than for the intended purpose
• incorrect assembly or installation, commissioning, operation and
maintenance of the A-ISOMETER
®
• failure to comply with the information in the operating instructions
regarding transport, commissioning, operation and maintenance
of the A-ISOMETER
®
• unauthorized structural modifications to the A-ISOMETER
®
• failure to comply with the technical data
• improperly executed repairs, and the use of spare parts or accessories
which are not recommended by the manufacturer
• cases of disaster and force majeure
• assembly and installation with device combinations not recommended
by the manufacturer
To Next Page
Loading...
