Benning IT 115 - Standards Applied

BENNING IT 115 Safety and operating instructions
- 12 -
2.3 Standards applied
The BENNING IT 115 installation tester is manufactured and tested in compliance with the
following regulations:
Electromagnetic compatibility (EMC)
EN 61326-1 Electrical equipment for measurement, control and laboratory use
– EMC requirements
Class B (hand-held equipment in controlled EM environments)
Safety (LVD)
EN 61010-1 Safety requirements for electrical equipment for measurement, control and
laboratory use – Part 1: General requirements
EN 61010-2-030 Safety requirements for electrical equipment for measurement, control and
laboratory use – Part 2-030: Particular requirements for testing and
measuring circuits
EN 61010-031 Safety requirements for electrical equipment for measurement, control and
laboratory use – Part 031: Safety requirements for hand-held probe
assemblies for electrical measurement and test
EN 61010-2-032 Safety requirements for electrical equipment for measurement, control and
laboratory use – Part 2-032: Particular requirements for hand-held and
hand-manipulated current sensors for electrical test and measurement
Functionality
EN 61557 Electrical safety in low-voltage distribution systems up to 1000 V
AC
and
1500 V
DC
– Equipment for testing, measuring or monitoring of protective
measures
Part 1: General requirements
Part 2: Insulation resistance
Part 3: Loop impedance
Part 4: Resistance of earth connection and equipotential bonding
Part 5: Resistance to earth
Part 6: Effectiveness of residual current devices (RCD) in TT, TN and IT
systems
Part 7: Phase sequence
Part 10: Combined measuring equipment for testing, measuring or
monitoring of protective measures
Reference standards for electrical installations and components
EN 61008 Residual current operated circuit-breakers without integral overcurrent
protection for household and similar uses (RCCBs)
EN 61009 Residual current operated circuit-breakers with integral overcurrent
protection for household and similar uses (RCBOs)
EN 60364-4-41 Low-voltage electrical installations – Part 4-41: Protection for safety –
Protection against electric shock
BS 7671 IEE Wiring Regulations (17
th
edition)
AS / NZS 3017 Electrical installations – Verification guidelines
Note on EN and IEC standards:
 This operating manual contains references to European standards. All standards of the
series EN 6XXXX (e.g. EN 61010) correspond to the respective IEC standards with the
same number (e.g. IEC 61010). They only differ in the modified parts due to the
European harmonization procedures.