38 Video wall installation guide
Optimizing the video wall performance and management: PL460/
PH460/PL550/PH550/PL490/PL552/PL553/PH5501/PH5502
To optimize the video wall performance, change the OSD settings as suggested.
1. Make sure the displays have been looped by IR, RS-232, or RJ45 connection.
2. Go to Tiling > Frame Comp. and set it to On.
3. Go to General settings > LED and set it to Off.
4. Go to General settings > Monitor ID and set different ID for each display.
5. Go to General settings > Switch on delay and set Auto or delaying time.
• You are provided with BenQ software to fully utilize the video wall management. Visit the
BenQ local website for the software and the user manuals.
Software Description
Multi-Display
Administrator (MDA)
A software program that enables remote and centralized
management of a single or multiple BenQ digital signage displays
on a host computer. You can create and edit display groups, view
status of displays as well as change display settings.
Use an appropriate RS-232C cable. Refer to the user manual or BenQ
service for more information.
Contact the BenQ customer service center for demonstration videos if
needed.
Color Management A software program that enhances the image uniformity of all
displays in a video wall application. You can also adjust color
settings of each display easily on a host computer, or backup and
restore calibration data quickly.
Use an appropriate RS-232C cable. Refer to the user manual or BenQ
service for more information.
Contact the BenQ customer service center for demonstration videos if
needed.
To Next Page
Loading...
