BestCode Next Series 8 Technical Manual October 2022 Page 142 of 290
• This problem is common when using the “Fastest” or “Ultra-Fast” setting.
• This problem may occur immediately OR only during parts of the day.
• The best solution is to reduce charge and check the Modulation Window. You may have to select a new frequency
range, but lower charge will work.
High Speed Print Distortion
If the issues shown are present on an 88HS, 88HS1, or 88SM, it may be necessary to reduce the charge % to as low as 40%.
Use Height 10 in the adjust screen to increase the print height while maintaining good print quality at charge 40%.
To Next Page
Loading...
