BestCode Next Series 8 Technical Manual October 2022 Page 78 of 290
Heavy Pigment fluids must be
shaken for 1 to 2 minutes to ensure
that the pigment is suspended in
the fluid and not caked to bottle.
Failure to shake to bottle will result
no pigment being in the tank. This
will make faint print that is not
bright.
7. Remove the Ink bottle, and remove the cap.
8. Insert the bottle and press firmly to break the
foil seal.
9. Wait for 1-2 minutes for the bottle to drain.
10. Discard the empty ink bottle in accordance
with local regulation.
11. Press OK on the Success screen prompt
(10-0001).
The BestCode Next Series 8 CIJ will allow a Makeup
bottle to be added when the Float switch in the
Makeup Tank is in the OK state.
The BestCode Next Series 8 CIJ will begin requesting a
Makeup bottle be added when the Makeup float
switch in the Makeup Tank is in the low state.
An on-screen prompt, Makeup Warning, 11-0003 will
occur every 6 minutes while the Makeup Tank is in
this State.
When the Makeup float switch is in the low state, 15
Makeup Adds will be allowed, and then a Makeup
Fault 11-0002 will occur.
The Jet cannot be started again until a new bottle of
SmartFill Makeup is added.
To Next Page
Loading...
