4
CHECKS AND MAINTENANCE
47
GB
1
2
CLUTCH CONTROL
CHECK OIL LEVEL
To check the oil level in the clutch pump,
fi rst remove cover 1.
Remove the two screws 2 and take off
cover 1 together with the rubber bellows.
With the clutch pump in a horizontal posi-
tion, the level of the oil should be 5 mm
below the upper rim.
Use the liquid indicated on page 18 in
the “Recommended lubricants and liquids”
table.
WARNING:
The fl uid is extremely corrosive. Take care
not to spill it on the paintwork.
2
1
BLEEDING CLUTCH CONTROL
• Remove the rubber cap 1 from the valve 2.
• Open the sump cap.
• Insert one end of a trasparent tube into
a container.
• Pump with the brake lever 2/3 times and
keep the lever pressed.
• Unscrew the valve and let the oil drain.
• If are still visible in the tube repeat above
operation until obtaining a continuous
outfl ow of oil within no air bubles.
• Close the valve and release the lever.
NOTE:
During this procedure, continuosly top up
the brake pump thank to replace the oil
that is out fl owing.
• Remove the tube.
• Replace the rubber cap.
To Next Page
Loading...
