Beyerdynamic MCS-D 200 - How to Operate the Chairman Microphone Unit; How to Display the Device ID; How to Display Messages; How to Adjust the Headphone Volume

MCS-D 200 – Microphone Units
53
6.4.2 How to operate the Chairman Microphone Unit
The chairman can turn on his microphone unit at any time irrespective of a selected limit:
Prior button
The “Prior” button  operates only, if the microphone unit has been programmed as a chairman unit via the MCS-D 200 control unit.
For a brief interruption or announcement the “Prior” button must be held down. If the microphone of the chairman microphone unit was
turned off, it will be turned on by pressing the “Prior” button. All the other activated microphones remain muted while the LED strip and
LED of the microphone button are flashing, until the “Prior” button is released.
By using the “Prior” button, chairmen of a higher level can mute the microphones of all delegate units as well as the microphones of all
chairman stations of a lower level.
Clear button
The “Clear” button  operates only, if the microphone unit has been programmed as a chairman unit via the MCS-D 200 control unit.
The functions of the “Clear” button described in the following refer to all operating modes.
Press briefly (< 1s):
The microphones of all speakers are deactivated simultaneously; requests to speak are not cleared.
Hold down (> 1s):
The microphones of all speakers are deactivated simultaneously; requests to speak are cleared.
6.4.3 How to display the Device ID
MCS-D 3173/3171 and MCS-D 3073/3071
In order to display the device ID  press the 5th button (on the very right) of the voting buttons  of the appropriate microphone unit.
During a voting the device ID cannot be displayed.
6.4.4 How to display Messages
MCS-D 3173/3171 and MCS-D 3073/3071
If a message is sent by using the iCNS software, it will appear in the LC display  of the appropriate microphone unit. In the second line
the message “Press Yes” will be displayed. This means the “Yes” button of the five voting buttons  has to be pressed to delete the
message.
During a voting pressing the “Yes” button the first time deletes the message; pressing the “Yes” button a second time means voting with
“yes”.
6.4.5 How to adjust the Headphone Volume
MCS-D 3173/3171 and MCS-D 3073/3071 as well as MCS-D 3143/3141 and MCS-D 3043/3041
Press the right or left navigator button  to adjust the volume of the headset connected to the microphone unit. When selecting the
volume the value (0 - 63) is displayed.
The settings remain stored even when the system is turned off.
6.4.6 How to select the Language or Channel
MCS-D 3173/3171 and MCS-D 3073/3071 as well as MCS-D 3143/3141 and MCS-D 3043/3041
Press the right or left navigator button  to select the available language channel, original channel (OR) or another information, audio or
music channel, which is then transmitted via the headphone connected to the microphone unit. The language channels are encoded
according to the international MARC language codes. Refer also to the chapter 12. “List of Language Codes”.