TG 1000 – Digital Diversity Receiver
12
• Quick Scan
Here you can select a channel or frequency from a predefined
group according to the respective region code (A, B, C, D or E).
Press the rotary switch to enter the submenu. Turn the rotary
switch to the left or right to select the requested group. From
the information at the bottom you can see how many channels
the group contains. Press the rotary switch to confirm the
selected group.
Now you can select a frequency group which can be scanned for
a channel. From the information at the bottom you can see how
many channels the group contains. Press the rotary switch to
confirm the selected group.
Now you can select a channel from the previously selected group
from which to start the scanning. From the information at the
bottom you can see the frequency of the selected channel. Turn
the rotary switch to the left or right to select the requested
channel. Press the rotary switch to confirm the selected channel.
The message “Scanning” will be displayed.
After the scanning, the next free channel will automatically be
selected. The selected channel and its frequency are displayed.
If you have selected the “Set All Ch in Network” option, the
“Frequency setting sent” message will be displayed when the
channel and appropriate frequencies have been sent to all
receivers in the network.
After the scanning, the existing receivers in the network will
display an information to select (Yes) or reject (No) the found
frequency for the receiver. Turn the rotary switch to the left or
right to select “Yes” or “No”. Press the rotary switch to
confirm your selection.
No = the existing frequencies for the channels will be maintained
Yes = the existing frequencies for the channels will be overwritten
The receiver from which the “Quick Scan” function was started,
will accept the found frequency in any case.
Important:
After performing the “Quick Scan” function, you must
synchronise the transmitter/s again. Refer also to chapter 2.10
“Synchronisation”.
Note:
As a user you can generate groups (“User Groups”) with
appropriate channels and frequencies by using the “Chameleon”
software, with which you can enter the groups into the receiver.
These groups are marked with a “U”.
▲ Freq: xxx.xxxMHz
• Quick Scan
▼ Handheld: xxdB
▲ Freq: xxx.xxxMHz
• Quick Scan
▼ Handheld: xxdB
Quick Scan
• Set: Ch 1 only OR
Quick Scan: Set Ch 1 OR SET ALL Ch in Network
• Search Group: xx
xx Channels (xxx - xxx MHz)
Quick Scan: Set Ch 1 OR SET ALL Ch in Network
• Start Channel: xx
Freq: xxx.xxxMHz
Quick Scan: Set Ch 1 Set Ch 1 OR SET ALL Ch in Network
Channel xx selected.
Frequency xxx.xxx MHz
Select the “Quick Scan” submenu
Perform the “Quick Scan” only for channel 1 OR for all channels in the network
Select the group which shall be scanned for a channel
Select the channel from which the scan shall be started
Display the selected channel and the appropriate frequency after the scan
Display of the receivers in the network after the scan and frequency transmission
1
Ch 1 only All Ch in Network
Quick Scan: All Ch in Network
• Set Frequency: No OR Yes
Don’t assign new frequency OR Assign new frequency
No
Yes
Don’t assign new frequency Assign new frequency
To Next Page
Loading...
