Beyonwiz DP-Lite - Other Ways to Change Service

STB & PVR Function
37
3) Other Ways to Change Service
There are other ways of changing services, as follows;
 CH+/CH- buttons: Press the CH+ or CH- buttons to change to the
next or previous service in the service list.
 NUMERIC buttons: Use the NUMERIC buttons to change to a service
directly e.g. to change to service 146, press the 1, 4, and 6 buttons
consecutively and then press
OK .
 RECALL button: Press the RECALL button to return to the previously
viewed service.
 Electronic Program Guide (EPG): You can change services by using
the EPG (see “EPG (Electronic Program Guide)” section later in this
chapter).
NOTE
 If you press the CH+ or CH- button continuously to change service,
only the information box will be updated to show your planned
service change. The service will then change 3 seconds after your
last button press.
 When the DP-Lite is recording two programs simultaneously, both
tuners are allocated for the recordings. Therefore you can only
change to a limited number of services during this time.
 When selecting channels using the numeric buttons, make sure you
know the channel number you wish to select. Channels can appear
on a different number in each state, e.g. Channel 10 is not always on
number 10 in the digital network.