51
BIFFI F01-2000 ELECTRIC ACTUATOR
INSTRUCTION AND OPERATING MANUAL
WARNING TABLE
Display message Condition for warning Action
Available controls
Alarm reset
Local Remote ESD
High torque in OP
(near max.)
Measured torque 10% lower than the
relevant value configured in torque set-up
or stroke limits routines
Check the torque necessary to
move the valve
Available Available Available Close control
High torque in CL
(near max.)
Measured torque 10% lower than the
relevant value configured in torque set-up
or stroke limits routines
Check the torque necessary
tomove the valve
Available Available Available Open control
Internal temp.
(nearlimits)
Temperature inside the actuator enclosure
higher than 80°C or lower than -35°C
Find the heat source and insulate
the actuator
Available Available Available Control temperature
>-35°C and <80°C
Main voltage
(nearlimits)
Value of the main voltage out of the correct
range (-15% or +10% of the value stated in
the nameplate menu) or wrong frequency
Check section of wires and
values of voltage and frequency
Available Available Available Main voltage correct
Contactor cycles
(max.)
Max. number of contactor cycles reached Change contactor and reset
operation log
Available Available Available Clear recent data log
Maintenance request Date of the next maintenance reached Perform maintenance and
setnext maintenance date
Available Available Available Change date
Motor current Motor current greater or lower than limits Check electrical motor Available Available Available Current OK
Wrong stroke limits The routine that monitors the stroke limits
detects a wrong end of travel condition
Re-calibrate both stroke limits Available Available Available Re-calibrate both
stroke limits
13 PARTS LIST AND DRAWINGS
13�1 INTRODUCTION
This chapter includes the drawings and parts
list of each component and subassembly of
F01-2000 actuators.
IMPORTANT
- When ordering spare parts, please indicate
the serial number embossed on the actuator
nameplate.
- When ordering spare parts, please refer to
the marked part list items on the attached
drawings.
- Recommended spares are marked with
thissign* on parts list.