BIFFI ICON-030 - Terms and Conditions; Manufacturers Liability; Storage and Pre-Installation; Storage Procedure

December 2019
160
Installation, Operation and Maintenance Manual
VCIOM-08500-EN
Appendix
Appendix
E.4 Terms and Conditions
Emerson guarantees every product to be free from defects and to conform to industry
standards. Unless otherwise specied, the warranty period is one year from the date of
installation by the rst user or eighteen months from the date of shipment to the rst
user, whichever occurs rst.
No warranty is given for products that are subject to improper storage, improper
installation, misuse, or are modied or repaired by unauthorized personnel.
Repair work resulting from improper use will be charged at standard rates.
E.5 Manufacturer's Liability
Emerson will not accept any liability in the event of:
• Use of product in a fashion that contravenes local safety at work legislation.
• Incorrect installation relating to, disregard for, or incorrect application of the
instructions as provided on the product nameplate and in the Installation,
Operation, and Maintenance Manual MAN-02-04-97-0713 and Appendix E within.
• Modication of the product without Emerson authorization.
• Work done on the product by unqualied or unsuitable personnel.
E.6 Storage and Pre-Installation
E.6.1 Storage Procedure
NOTICE
Not following the procedures according to this document will invalidate the product warranty.
Normally the optional extension for additional entry or additional electronic card is directly
mounted on the base model of ICON3000 and leaves the factory in perfect condition. In
this case the general storage procedure as stated in section 2 must be followed. When the
above extension is shipped separately for a eld upgrade on an existing ICON3000 unit, this
extension must be stored in a protected area while ensuring that the explosion-proof joints
are well-protected and kept free of damage. The standard plastic plugs used to protect the
conduit entries during transport are not explosion-proof nor waterproof; these plugs are
only intended to prevent entry of foreign objects. The extension for additional entry/entries
or additional electronic cards maintains the same weather-proof degree of protection as the
base ICON3000 model. Good operating condition can only be maintained if the extension is
correctly installed/connected on site and if it has been correctly stored.