BIFFI ICON-030 - Maintenance Date; Data Logger

December 2019
84
Installation, Operation and Maintenance Manual
VCIOM-08500-EN
Section 10: View Routines
View Routines
10.4.5 Maintenance Date
The routine allows the following dates to be viewed:
• Last date
• Next date
• Start-up date
• Recent log date
(see Table 17 below)
Table 17.
View procedure
• Move the local selector to OFF and then simultaneously press OPEN and STOP.
Select the language according to the instructions (see “Entering the view mode”).
When the message displayed is “VIEW MODE OK?” press YES. Press NO to scroll
through the list of available menus and press YES to select the "Maintenance" menu.
• Press NO to scroll through the list of available routines and press YES to select the
"Maintenance Date" date routine.
• Press YES to scroll the list of dates.
10.4.6 Data Logger
The “data logger” routine allows collection of different types of data useful for
maintenance or for diagnostic programs. Since the amount of collected data is very large,
the data logger can only be viewed via a PDA or PC. The data can be uploaded from the
ICON3000 to a PDA or PC via a Bluetooth wireless connection.
The local display only allows viewing of congured parameter values (see also SET-UP
menu, Maintenance, Set data logger, Section 9.3.7).
The following data can be viewed on the local display:
• Logger mode
• Sampling time
• Memory mode
• Date
• Time
Last date
This is the date of the previous maintenance operation. This date should be updated
by the user after all maintenance operations (see Section 9.3).
Next date
This is the date of the next scheduled actuator maintenance. When the date is
reached, the ICON3000 generates a maintenance request warning. The date
should be updated by the user after all maintenance operations (see Section 9.3).
Start-up date
This is the date of actuator start-up. During commissioning, the user should enter
the start-up date (see Section 9.3).
Recent log
date
This is updated after entering command “Clear recent data log” (see Section 9.3).
This command clears the “recent data log” counters. The content of “recent log”
is updated starting from “recent log date”.