BIFFI ICON-030 - Valve Data; Sample Configuration Procedure; Maintenance

December 2019
70
Installation, Operation and Maintenance Manual
VCIOM-08500-EN
Section 9: Set-Up Routines
Set-Up Routines
9.2 Valve Data
The valve data allow identication of the valve and its function in the process. The valve
manufacturer and the end user can enter the data. The following data can be entered:
• Tag name (max. 28 characters)
• Serial number (max. 28 characters)
• Manufacturer (max. 28 characters)
• Break OP torque (max. 28 characters)
• Break CL torque (max. 28 characters)
• Max stem thrust (max. 28 characters)
• Flange type (max. 28 characters)
9.2.1 Sample Conguration Procedure
Tag name
• Move the local selector to OFF and then simultaneously press OPEN and STOP.
Select the language and enter the password according to the instructions
(see “Entering the set-up mode”). When the message displayed is “SET-UP MODE
OK?” press YES. Press NO to scroll through the list of available menus and then
press YES to select the "Valve Data" menu.
• Press NO to scroll the list of available routines and then press YES to select
"Tag Name".
• Press YES if the 1st character of the string is correct. Press NO to scroll through
the list of available characters. Press YES to select the desired character.
• Enter up to 28 characters. Enter a blank character, followed by “ ” to mark the end
of the string.
The conguration of all other valve data items is performed in the same way, by selecting
the relevant item from the list of available routines.
9.3 Maintenance
A large amount of data is stored in the actuator memory and is available for future
analysis or to assist the operator in a maintenance program. The maintenance menu also
includes the set password routine and the potential to modify or start the maintenance
functions. The following data are available:
• set password
• clear alarm log
• set torque reference
• set curve reference
• clear recent data log
• set maintenance date
• set data logger