Bilancial BTEK DD 700 - Piece Number String(**)

12
ADVANCED USE MANUAL DD700
1st character
<STX> (02H)
2nd character
<SP> (20H)
or <->
Space if the weight is positive
Minus sign if the weight is negative
3rd-8th character
weight
9th character
<SP> (20H)
space
10th-11th character
<um>
unit of measurement (kg, oz or lb) As explained
above, if the weight is expressed in g or in t, the
unit
of measure of the string only occupies one
character (10th), subsequently the numbering of
the following characters decreases by one unit.
12th-13th character
<GR> or
<NT>
GR = gross weight
NT = net weight
14th character
<O> or
<A> or
<U>
O = OVER
A = ACCEPT U = UNDER
15th character
<M> or
<R> or
<SP>
M = unstable weight
R = overload
SP = valid and stable weight. This character is
only there if the protocol is cyclical, in all other
cases the numbering of the
following characters drops by
one unit.
16th character
<CR> (0DH)
17th character
<LF> (0AH)
2.2.10 Piece Number String(**)
The Piece Number String can only be selected in “Contapezzi” (piece count) mode.
1st character
$ (24H)
string start character
2nd-7th
character
number of pieces
8th character
<CR> (0DH)
string end character