Bilancial BTEK DD 700 - Setup Menu;Customisation;Operating Modes;Printer;Model

62
ADVANCED USE MANUAL DD700
3.6.9 Setup Menu/Customisation/Operating modes/Printer/Model
It is possible to select the type of printer and its operating parameters.
STB80
Thermal printer
Tape Ejection
Select YES for the automatic ejection of the printing module and therefore facilitate
removal, otherwise select NO.
Cut Type
Determine the cutter mode at the end of each printout.
If you select:
NO
no cut is made;
Partial
a partial cut is made;
Complete
a complete cut is made.
Printing width
It determines a number of 42 or 32 characters per line.
Manufacturer Printing
Select YES to enable printing out the name of the manufacturer of the instrument,
otherwise select NO:
STB112
Thermal printer
Continuous module printer Standard configuration manages modules with a width
of 112 mm with a maximum of 64 characters per line.
Tape Ejection
Select YES for the automatic ejection of the printing module and therefore facilitate
removal, otherwise select NO.
Cut Type
Determine the cutter mode at the end of each printout.
If you select:
NO
no cut is made;
Partial
a partial cut is made;
Complete
a complete cut is made.
Module Type
This defines the type of printer module, which can be Tape, Card, Label.
Print Density
Determine the print density: -50% -25% NORM 25% 50% 100% 125% 150%
Printing width
Determine the width of the printing module: 80mm, 112mm.
Manufacturer Printing
Select YES to enable printing out the name of the manufacturer of the instrument,