ADVANCED USE MANUAL DD700
3.6.10 Setup Menu/Customisation/Operating Modes/Printer/Port
It is possible to configure, or not, a serial output, for the connection of a printer in text mode
(NO,Com1,Com2).
3.6.11 Setup Menu/Customisation/Operating modes/Printer/Printouts
It is possible to select the characteristics of the print format.
Gross weight printing
To enable the printout of the gross weight, select YES, otherwise select NO.
Tare printing
It is possible to enable printing out the tare. If you select:
preset
the tare will only be printed if it is preset;
other than 0
the tare will only be printed if it is not zero;
always
the tare will always be printed.
Barcode printing
To not enable barcode printing select NO, otherwise, depending on the required
barcode, select:
Net
Code Product + Net (code 128)
Code Product + Net (indicod ean13)
Code Generic + Net
Product Code + Pieces (code 128)
Pieces + Net (code 128) (OPTIONAL)
Code Product + Pieces (indicod ean13) (OPTIONAL)
Pieces + Net (indicod ean13) (OPTIONAL)
Code Product (6 digits) + NewNet indicod ean13(OPTIONAL)
Date Time printing
To enable printing date and time on the printing module select YES, otherwise
select NO.
Number of weight printing copies
This determines the number of copies you wish to print automatically (only for
STB112, STB80, DPT282, STB60, Q3, ZEBRA and PLUS).
Set the numerical value according to the instructions in the user manual, in the
chapter on Using the terminal.
Logo printing
To enable logo printing, select YES, otherwise select NO.
Logo printing is only enabled for the following printers: STB112, STB80, STB60,
Q3, ZEBRA ).
This enables the customised printouts and/or strings stored in the memory.
To Next Page
Loading...