Bilancial BTEK DD 700 - Page 66

66
ADVANCED USE MANUAL DD700
Peeling (dots): 0 (default value). It must be set according to the instructions in the
user manual, in the chapter on Using the terminal.
Speed: 50.8 (default value). It must be set according to the instructions in the user
manual, in the chapter on Using the terminal.
Label Origin X (mm)
Label Origin Y (mm)
Logo Length (mm):
Q3X
Thermal printer
Roll expulsion
Select YES for the automatic ejection of the printing module and therefore facilitate
removal, otherwise select NO.
Type of cutting
Determine the cutter mode at the end of each printout.
If you select:
NO
no cut is made;
Partial
It runs a partial cut
Print width: 42,32
It determines a number of 42 or 32 characters per line.
Print manufactures: Yes,NO
Select YES to enable printing out the name of the manufacturer of the instrument,
otherwise select NO.
LP55
Thermal printer
Roll expulsion
It performs the advancement of the print module to position it correctly for ripping.