Bilancial BTEK DD 700 - Remote Commands for Input;Output Management; Setting a Single Output; Resetting a Single Output

To Next Page

To Previous Page

ADVANCED USE MANUAL DD700

2.5 Remote commands for Input/Output management

2.5.1 Setting a single output

It is possible to set output n2 of slot n1 using command:

SO n1 n2 <CR>

where:

n1 is 1 hexadecimal character that defines the position of the output

slot;

n2 is 1 hexadecimal character that defines the output number on

slot n1.

n1 = 0 (30H) output on the terminal

n1 = 1 (31H) output on slot 1

n1 = 2 (32H) output on slot 2

n2 = 1 (31H) output number 1

n2 = 2 (32H) output number 2

n2 = 3 (33H) output number 3

n2 = 4 (34H) output number 4

2.5.2 Resetting a single output

It is possible to reset output n2 of slot n1 using command:

RO n1 n2 <CR>