Bilancial BTEK DD 700 - Scale Status Transmission Request (EV2001 Version); Scale Reset; Tare Acquisition; Entering a Tare

31
ADVANCED USE MANUAL DD700
2.4.11 Scale status transmission request (EV2001 version)
XS <CR> (XSb<CR>)
If positive, the terminal responds with the following string:
<s1><s2>< CR><LF>
Characters s1 and s2 are ASCII characters that must be interpreted as expressed in hexadecimals.
The bits identify the status of the weighing platform.
<s1>
bit 0
in range
bit 1
stable weight
bit 2
center of zero
bit 3
net displayed
<s2>
bit 0
not used
bit 1
not used
bit 2
not used
bit 3
print request: a print key was pressed or input num.3 is active.
2.4.12 Scale reset
AZ<CR> (AZb<CR>)
2.4.13 Tare acquisition
AT<CR> (ATb<CR>)
2.4.14 Entering a tare
nAT<CR> (nATb<CR>)
The AT command must be preceded by a weight expressed with a maximum of 7 characters,
including the decimal separator.
2.4.15 Deleting an entered tare
CT<CR> (CTb<CR>)
This command deletes any saved tare value.