Bilancial BTEK DD 700 - Weighing Operation Request from Serial Command with Transmission at End of Operation

49
ADVANCED USE MANUAL DD700
If Standard+date is selected in the Setup Menu the sent data will be:
1°character
$(24H)
2° character
M(4DH)
3° character
P(50H)
4°-13° character
Date(yyyy-mm-dd)
14° character
Space(20H)
16°- 22°
Time(hh:mm:ss)
23°
Z(5AH)
“z” identifies the type of date / time
universal orderable
24°-31° character
MPP identification code or
indications on scale status:
NO<SP>STAB weight not stable
NO<SP>VAL<SP> weight not valid
ERRMEM<SP> weight
storage error
32°-39° character
Weight with sign and any decimal
separator
40°-41° character
<um>
Unit of measurement
42°-43° character
<CRC>
String control field.
The calculator responds with:
<ACK> (06H) if the string arrives correctly;
<NAK> (15H) if the string does not arrive correctly; in this case the terminal repeats the data
package. After three negative responses or no response, the terminal displays an error message.
WARNING
the ACK/NACK protocol is automatically enabled in MPP mode.
2.8.3 Weighing operation request from serial command with transmission at end
of operation
After loading the weight onto the weighing platform, send the storage command and data request
through the calculator:
MP<CR> (MPb<CR>)
With a positive response, depending on the item selected in the Setup Menu (Standard, Terminal
Number, Serial Number), the terminal sends one of the strings previously described in par. 2.8.2 in the
same way.