Bilancial BTEK DD 700 - Page 63

63
ADVANCED USE MANUAL DD700
otherwise select NO.
It is only possible to print the manufacturer name with tape printers.
Line Feed output
only in case of form on the card.
Epson TM295
Multicopy card printer
Card Lock
Select YES to lock the card to the printing plate, otherwise select NO.
Card Ejection
Select YES to automatically eject the card at the end of printing, otherwise select
NO.
Line Feed
Number of feeds to be set to adapt card printing
Line Feed output
Number of feed to be set to adapt the printing output to the card
Epson
LX300+
80-column printer (formatted to print 40 characters per line).
Page Length
This determines the length of the printing page. Set page length by number of lines.
If you enter 0, the programmed page will be managed on the printer.
Skip Page: YES, NO
Type of Module
This defines the type of printer module, which can be Single or Continuous.
Line Feed
Number of line feed to the print start
Line Feed output
Number of feed to be set in the case of single module
DPT282
Thermal printer
Tape Ejection: YES, NO
This advances the printing module to position it correctly for tearing.
TM300
Tape printer
Tape Ejection: YES, NO
This advances the printing module to position it correctly for tearing.
Activate low paper sensor
The sensor is positioned on the paper roll feeder and detects, by assessing the
diameter of the roll itself, when the paper is almost
finished.
An LED lights up when the paper is almost finished.
To enable the sensor, select YES, otherwise select NO.