Bilancial BTEK DD 700 - Page 70

70
ADVANCED USE MANUAL DD700
String end
characters
<CR>, <CR> <LF>
Only for CW
protocol
Cyclical, On request, ACK-NAK, With remote commands
Configuration
Refer to the dedicated paragraph for the hardware characteristics of the
serial output.
Checksum
mode
To enable checksum mode, select YES, otherwise select NO. It can only be set if
the selected string is Extended, Cma, Request with address or Extraction.
For further details, refer to the dedicated paragraph.
Barcode
reader
Data associated to
Set the General data number as explained in the Using the terminal chapter in
the user manual.
The list of general data with relative associated number is reported in the
dedicated paragraph.
Code Type
CB Standard
Set the control digit as explained in the Using the terminal chapter in the user
manual.
Neutral
Type of generic code.
It is possible to choose the Used code digits by selecting All or by setting
the Interval(OPTIONAL), From position To position, as explained in the using
the terminal chapter in the user manual.
Configuration
Refer to the dedicated paragraph for the hardware characteristics of the serial
output.
Automatic printing
NO
YES
Provide the starting the weighing after the reading of the barcode.