Bilancial BTEK DD 700 - Page 88

88
ADVANCED USE MANUAL DD700
Unit of measurement
It is possible to view the selected unit of measurement chosen during installation.
Division
It is possible to view the minimum division value (expressed in the selected unit of
measurement) selected during installation.
Cma
See dedicated paragraph.
Num. of terminal for interrogation: it must be set according to the instructions in
the user manual, in the chapter on Using the terminal.
Repeater terminal Num.: it must be set according to the instructions in the user
manual, in the chapter on Using the terminal.
Num. of terminals that it is possible to interrogate (normally 1). It must be set
according to the instructions in the user manual, in the chapter on Using the
terminal.
Reading time
This displays the interrogation time of the main terminal (in hundredths of
seconds).
Automatic print: YES, NO
Enable reset: YES, NO
This enables resetting the repeater terminal towards the main terminal
Enable selfw. tare: YES, NO
This enables the self-weighed tare on the repeater terminal towards the main
terminal.
Enable preset tare: YES, NO
This enables the preset tare on the repeater terminal towards the main terminal.
Gibertini
Mettler
Sartorius
Fulgor
Worldweigh
Unit of measurement
It is possible to view the selected unit of measurement chosen during installation.
Division
It is possible to view the minimum division value (expressed in the selected unit of
measurement) selected during installation.
Tare device: activated, auto tare only, Pre-set only, De-activated.
Capacity
It is possible to view the capacity set during installation.
Tare lock: yes, no