KBF / KBF-UL + KMF (E6) 09/2021 page 14/160
The chamber does not dispose of any measures of explosion protection.
DANGER
Danger of explosion due to introduction of flammable or explosive substances in
the chamber.
Serious injury or death from burns and / or explosion pressure.
∅ Do NOT introduce any substance into the chamber which is combustible or explosive at
working temperature.
∅ Do NOT introduce any combustible dust or air-solvent mixture in the inner chamber.
Any solvent contained in the loading material must not be explosive or inflammable. I.e., irrespective of the
solvent concentration in the steam room, NO explosive mixture with air must form. The temperature inside
the chamber must lie below the flash point or below the sublimation point of the loading material. Familiarize
yourself with the physical and chemical properties of the loading material, as well as the contained moisture
constituent and its behavior with the addition of heat energy and humidity.
Familiarize yourself with any potential health risks caused by the loading material, the contained moisture
constituent or by reaction products that may arise during the temperature process. Take adequate
measures to exclude such risks prior to putting the chamber into operation.
DANGER
Electrical hazard by water entering the chamber.
Deadly electric shock.
∅ The chamber must NOT become wet during operation, cleaning, or maintenance.
∅ Do NOT install the chamber in damp areas or in puddles.
Set up the chamber so that it is splash-proof.
The chambers were produced in accordance with VDE regulations and were routinely tested in accordance
to VDE 0411-1 (IEC 61010-1).
During and shortly after operation, the temperature of the inner surfaces almost equals the set-point. The
glass doors, the glass door handles, and the inner chamber will become hot during operation.
CAUTION
Danger of burning by touching hot chamber parts during operation.
Burns.
∅ Do NOT touch the inner surfaces, the glass doors or the loading material during opera-
tion.
WARNING
Danger of injury and damages by the chamber tipping over or breakaway of the pro-
truding lower housing cover.
Injuries and damage to the chamber and the loading material.
∅ Do NOT load the lower housing cover with heavy objects while the chamber door is
open and do NOT climb on it.
To Next Page
Loading...
